160030 PolyCarb Roofing Washers
These 22mm Dome washers are designed for use with Polycarb and softer profile materials. They allow for expansion holes to be drilled and are suitable for use with 12g & 14g screws.
• Provides a waterproof Seal
• Allows for expansion, contraction and movement of the Polycarbonate roofing sheet
• Suitable for use with 12g and 14g SteelMates® and TimberMates®
• Allows for expansion, contraction and movement of the Polycarbonate roofing sheet
• Suitable for use with 12g and 14g SteelMates® and TimberMates®
Step 1:-
Select the correct fastener required for your intended application, either a SteelMates® for steel substrates or TimberMates® for timber substrates and assemble the Polycarb onto the fastener selected
Step 2:-
If fixing Polycarbonate or fibreglass roofing a clearance hole is specified by the profile manufacturer, check their specifications and pre- drill the correct size hole
Step 3:-
Ensure the correct driver tool is fitted to your power drill or screw driver.
Step 4:-
Place the screw on the driver tool and position it onto the materials being fastened.
Step 5:-
If necessary push sharply to create a centre mark and to prevent screw wander.
Step 6:-
Squeeze trigger and maintain steady, constant pressure until the screw has drilled and fastened.
Recommended Driving speeds:-
• For SteelMates® fixing into steel 1,800~2,000 r.p.m.
• For Timbermates® fixing into timber 800 to 1,000 r.p.m.
• For Timbermates® fixing into thin metal battens 1,800 to 2,000 r.p.m.
Select the correct fastener required for your intended application, either a SteelMates® for steel substrates or TimberMates® for timber substrates and assemble the Polycarb onto the fastener selected
Step 2:-
If fixing Polycarbonate or fibreglass roofing a clearance hole is specified by the profile manufacturer, check their specifications and pre- drill the correct size hole
Step 3:-
Ensure the correct driver tool is fitted to your power drill or screw driver.
Step 4:-
Place the screw on the driver tool and position it onto the materials being fastened.
Step 5:-
If necessary push sharply to create a centre mark and to prevent screw wander.
Step 6:-
Squeeze trigger and maintain steady, constant pressure until the screw has drilled and fastened.
Recommended Driving speeds:-
• For SteelMates® fixing into steel 1,800~2,000 r.p.m.
• For Timbermates® fixing into timber 800 to 1,000 r.p.m.
• For Timbermates® fixing into thin metal battens 1,800 to 2,000 r.p.m.
• For providing a water tight seal over the expansion holes needed when fixing Polycarbonate sheeting.
• Used in conjunction with 12g & 14g SteelMates® or TimberMates® screws.
• Used in conjunction with 12g & 14g SteelMates® or TimberMates® screws.
| Size | Pack Type | Code |
|---|---|---|
| 12g-14g x 22mm |
|